Page 2 of 2

Re: Need a little help

Posted: June 30th, 2016, 6:41 am
by Kerri
I'll try Google and see what I can find out about this.
I do believe I'll take a wrench to it. Flush that tank out and retailer it and put back in place.
Thank you for your help

Kerri

Re: Need a little help

Posted: June 30th, 2016, 5:22 pm
by Kerri
After getting into the hot water heart I saw that it is a Suburban Model 5032 SW6D 6 gallon tank. It's a 1997 Chinook.

I could only wish I had the manual that came with this. After awhile I feel silly asking all the questions. But you people are good enough to help me through this.

Thank you once again
Kerri

Re: Need a little help

Posted: June 30th, 2016, 8:28 pm
by Blue~Go
Hey, no worries. That's the typical stock Chinook water heater (still easily available, as are parts).

Here is a link to the manual (says installation but is also for operation):

http://manuals.adventurerv.net/SW6D-SW6 ... lation.pdf

This is what the anode rod looks like (you can see why I think yours has been replaced with something else)... On top a fresh one and on the bottom one that should have been changed sooner! Just the hex head sticks out to where you can see it - the rest is inside.
anode rods.png

Re: Need a little help

Posted: July 1st, 2016, 3:30 am
by Kerri
Thank you so much for this!
Kerri