Generator junction box location

Split from General / Technical for discussion of anything electrical, electronic... 12v, Inverter, Satellite, Headlights, flashlights etc.
Post Reply
chin_k
**Forum Contributor**
Posts: 2257
Joined: June 26th, 2017, 9:38 pm
Location: Southern CA

Generator junction box location

Post by chin_k »

The manual Fig 9.1 shows that it is in the closet. I looked, but can't find it. It is under the carpet that I need to remove to see it?
2000 Concourse dinette, on 1999 6.8L Ford E350 Triton V-10 Chassis
User avatar
HoosierB
**Forum Contributor**
Posts: 473
Joined: May 21st, 2015, 7:00 pm
Location: South Bend, Indiana

Re: Generator junction box location

Post by HoosierB »

I believe there is a carpeted "false floor" covering the junction box area.
"Wanda" – '01 Chinook Concourse XL V10
chin_k
**Forum Contributor**
Posts: 2257
Joined: June 26th, 2017, 9:38 pm
Location: Southern CA

Re: Generator junction box location

Post by chin_k »

I see. I'll try to open up the area without making a mess then. Thanx.
2000 Concourse dinette, on 1999 6.8L Ford E350 Triton V-10 Chassis
User avatar
HoosierB
**Forum Contributor**
Posts: 473
Joined: May 21st, 2015, 7:00 pm
Location: South Bend, Indiana

Re: Generator junction box location

Post by HoosierB »

It's more of a pressure fit, not really screwed or nailed in place. Mine had a small cloth strap attached to the carpeted wood false floor... just pull up on it and the panel is free.
"Wanda" – '01 Chinook Concourse XL V10
User avatar
Blue~Go
Senior Member
Posts: 3797
Joined: July 31st, 2014, 1:01 am
Location: 1999 Concourse

Re: Generator junction box location

Post by Blue~Go »

Same here. In the "low" section of the closet right by the back wall, there is a carpeted section of floor that is around 8" x 16", and rounded on one corner. That has two plywood "feet" it sits on which hold it up over the generator junction box. Mine also had a strap you could lift up on to pull it out. Below the junction box is the regular plywood coach floor.
1999 Concourse
chin_k
**Forum Contributor**
Posts: 2257
Joined: June 26th, 2017, 9:38 pm
Location: Southern CA

Re: Generator junction box location

Post by chin_k »

Thank you, guys. I'll take a look and see if I have the identical setup.
2000 Concourse dinette, on 1999 6.8L Ford E350 Triton V-10 Chassis
Post Reply