Awing

Everything about Chinooks that isn't option specific. Please check if your post is more appropriate in another category before posting here.
Post Reply
Carolann22
Posts: 8
Joined: June 2nd, 2022, 3:16 pm

Awing

Post by Carolann22 »

Learning to open awning. The support arms when closed seem to fit behind red tabs. Are the screws holding the red tabs loosened and tightened each time the awning is used
Trying to figure out how to upload a picture.
I have a 2004 Concourse
deppstein
**Forum Contributor**
Posts: 319
Joined: July 13th, 2015, 7:07 am

Re: Awing

Post by deppstein »

No Ned to loosen the screws holding the end tabs of the arms in the red thing. Once you have awning open, loosen the turn screws at outside end of each arm and then slide arm back (toward outside edge). This will bring the other end of the arm out from its holding place. Rotate the arms on the pivot and insert the end into the holder on side of Rig body. Then insert the middle pole of awning (adjust length using turn screw) then raise each side to desired height, again using turn screw on each arm.
Taking awning down is process in reverse.
If not clear, happy to elaborate. Good luck.
David
Carolann22
Posts: 8
Joined: June 2nd, 2022, 3:16 pm

Re: Awing

Post by Carolann22 »

Thanks I’ll give it a try
Carolann22
Posts: 8
Joined: June 2nd, 2022, 3:16 pm

Re: Awing

Post by Carolann22 »

Got it. It was so easy after learning the right way. Thanks so much
Post Reply